Is my phone bricked?

[classof2011]

Hey, I brought my old grey V3i to my computer. After flashing it with a ChinaMobile flex that said couldn't be changed, I hated it and still tried to change it back. Now it just shows the bootloader, which states :

Boot Loader
0A.30.
SW Version:
R4441D_G_08.02.05R

OK to Program
USB
Transfer Mode


And RSDLite detects it and when I try to flash it says successful, but it just stays on bootloader the moment I insert the battery.

Is there any way I can delete EVERYTHING and re-install EVERYTHING?

Thanks.

[prybar]

you'll need to testpoint i believe....

regards

pry

[Dilbert]

Your stuck with R4441D_G_08.02.05R. Flash it again and you'll be fine. Just change the flex afterwards but the flash must remain.

[prybar]

thanks for clarifying dilbert....i meant testpoint to be free...

pry

[classof2011]

I used this to reflash it, and it didn't help. It still shows the unchanged bootloader

Wait. That's a flash. Should I use a flexlash to try and get it working again?


So how do I make a testpoint?

Also, where do I get P2K ET?

[vanzk102]

Dont use reflash, use a Monster Pack which has the same S/W version with your phone. Your current firmware is a sticky, cant flash back to older firmwares.

[classof2011]

I have it fixed now, but it still has the ChinaMobile stuff. So to remove that, I just go through on P2KTools and take out all the ChinaMobile-labeled stuff?

Also, the center button and a few others do not work!