PEBL stuck in Bootloader

[ECACE]

I was given a PEBL recently that had TMob stock FW in it, and I wanted to just change it to stock Mot. So I used FB3 and flashed down the following MP's:

R478_G_08.83.55I_PDS004_LP0039_DRM0101_VSTUK_ENGLI : Stock MonsterPack (16.57 MB)

Milkbone98 Pebl Mod 1.2

Both with the same effect: Stuck in boot loader

Boot Loader
08.A1
SW Version:
R478_G_08.84.2
FR
PHONE CODE SIG
ERROR:

Ok to Program
USB
Transfer Mode

So how do I get it out of boot loader? I did make a backup with FB3 before trying any of this and have tried to dump it back on, same thing. Any help you can offer would be appreciated.

[Pzyduck]

Only flashing CG2, CG4 and CG15 with this MonsterPack:MP Pebl U6 MaxMod V1.0


if you do not solve the backup does everything except flashing CG2, CG4 and CG15, with the latest version of Flash & Backup 3.0.9 (the opposite), and see if you can.

If still the same flashealo with RSD Lite 4.6 with the Backup



Regards

[ECACE]

Tried the MP you listed and only dumping those CG's to no avail, then tried the whole MP, again, no avail, then I did that MP along with the bootloader available in the PEBL DL section and... SUCCESS !!!!!!!! I am now a happy camper.

I just got to load some other skins and I think all will be well.
Having never played with a PEBL before, does it handle speed dial #'s different? For example if I have highlighted a # in my phonebook, I would expect to see an option there to assign it to speed dial XYZ, but it is not there. I will check if that was something in seem32 to enable that, can't remember off hand though.

Thanks for the help in getting it back. This MP looks like it should be good.

[Pzyduck]

You can flash the MonsterPack but only let you flash the CG2, CG4 and CG15


Regards

[ben23]

Tried the MP you listed and only dumping those CG's to no avail, then tried the whole MP, again, no avail, then I did that MP along with the bootloader available in the PEBL DL section and... SUCCESS !!!!!!!! I am now a happy camper.

I just got to load some other skins and I think all will be well.
Having never played with a PEBL before, does it handle speed dial #'s different? For example if I have highlighted a # in my phonebook, I would expect to see an option there to assign it to speed dial XYZ, but it is not there. I will check if that was something in seem32 to enable that, can't remember off hand though.

Thanks for the help in getting it back. This MP looks like it should be good.

i have the same problem and i cant fix it.
can you give me the dierct link of the bootloader that you downloaded from the pabel dl section?

[Dohs]

TP reflash is the best

[chris_rzr]

hello... i'm back again... its been a long time with no visits here...

i am using my pebl again... but i still have this "pain in the a**" problem that everytime i try to pass to BL mode it doesn't reboot and have to take out the battery to reset the power succesfully, but the BootLoader don't run... what's wrong with it? i saw that my phone has a TP made (it is opened in the TP point) but... could somebody succesfully made a TP but kill the BL??? that's the only reason i see for this problem... Can you give me some tips about what to do to make the BL work again? i can't flash/backup my phone...