Try the first process of the above post.
Or try charging your battery by using someone else's L9.
Battery is charged with jadoo but phone is in same condition as earlier.
lost state continued..................................
any hope to revive this phone.????????????
phone shows connected ,when connected to pc. there after i dont know what to do.??????????????
Is it showing connected in FlashnBackup 3??
Try flashing again.
i am also suffering from d same prblm....it all happened in the course of rsa removal....
There are guides to recovering your L9 if you have the PDS backup.
it shows connected in f&b3, i tried to flash it again with fb306/p2k but again stuck with following error.
Soumya I want to check & verify whether I am doing everything correctly or not. from where i can get the complete procedure to identify current status of my l9 and further how to resolve & revive L9
error going to address 66879504
invalid pointer operation
F&B 3.0.6 error
*** Operation start (1/8/2011 3:50:44 PM) ***
Write data: C:\Program Files\Motorola Tools\Flash&Backup 3\BackupsNew\2010-05-27_203840\2010-05-27_203840.shx
Extracting data from firmware file...
Sending the loader...
Erasing memory... (Progress of this process is not shown)
Sending code group: CG1
Sending code group: CG2
Sending code group: CG3
Sending code group: CG4
Sending code group: CG7
Sending code group: CG8
Sending code group: CG15
Sending code group: CG18
*** Operation end (1/8/2011 3:51:40 PM) ***
how to resolve executing JUMP error
Last edited by pavan_2k; 01-08-2011 at 08:13 AM.
Reason: Automerged Doublepost
I'll be frank. I have very little idea about RSA removal and RSA removed L9s.
But maybe [MENTION=3178492]thetuxracer[/MENTION] can help.
we are all inexperienced in RSA. i thought pavan had given his cell to the repair center by now!
it didnt work buddy..same error of flashing failed..
hello.....to all.... Dr.Motorola L9.....is there some solution available to my problem. i m totally blank now....i have downloaded & followed almost all links.....still L9 is in brick mode.
It would be greate if someone could help me with which software tobe used and how. stepwise procedure to identify and resolve this problem.
It seems that it is challenging but not impossible.
help -- l9
Tags for this Thread